Elevator finally complete!

OK, so I got the correct trim tab, and guess what? It had some damage!

But, I managed to fix it, and get it installed. So finally the end of that ordeal.

Also added the rivnuts to hold the trim tab servo access plate:

The eight holes surrounding the opening, for the rivnuts, are undersized. So I will have to open them a little bit. But, they are quite close to the edge of the opening, so I will need to support the area when I drill. I'm doing this with clams a piece of wood, simple and effective (Two clamps were actually used, one on each side of the hole):

All done:

I also put on the other elevator tip:

And I can now call the elevator finally done (for now)! Woohoo!