Posts

Showing posts with the label trim tab

Elevator finally complete!

Image
OK, so I got the correct trim tab, and guess what? It had some damage! But, I managed to fix it, and get it installed. So finally the end of that ordeal. Also added the rivnuts to hold the trim tab servo access plate: The eight holes surrounding the opening, for the rivnuts, are undersized. So I will have to open them a little bit. But, they are quite close to the edge of the opening, so I will need to support the area when I drill. I'm doing this with clams a piece of wood, simple and effective (Two clamps were actually used, one on each side of the hole): All done: I also put on the other elevator tip: And I can now call the elevator finally done (for now)! Woohoo!

More Trim Tab Woes & Elevator Progress!

Image
Bad news first. That new, shiny, perfectly straight trim tab? Yeah, it's the WRONG PART! Apparently it was mislabelled as a left trim tab, when it is in fact a right one: The top 2 are my previous, old and busted ones, notice the shape and angle on the right, and the location of the holes for the control horn. The bottom one is reversed! So I guess I'll go ahead and get a *4th* one. But, not to worry, this hasn't stopped me from making good progress on the rest of the elevator: Getting the skin on just right was a bit of a challenge, but I'm quite happy with the result. I gotta say, placing it vertically sure helped: stand at the end, look down the edge, look at the ribs, etc. and adjust as needed. Doing this laying flat on a table would've been far more painful, having it to flip it over constantly (That trim tab is an old dented one, but for the purposes of fitting everything it works fine, it's not yet one permanently). I...

Elevator #2 Progressing!

Image
I re-started my elevator as I had botched the first one (entirely my fault). Here it is ready to be skinned: And I finally got a *perfect* trim tab, very very straight! Third time's the charm:

Elevator challenges

Image
Not been having luck lately! First, settings the rivets int he control horn didn't work quite as planned. One stem ended up loose, and one ended up crooked. Because these are stainless steel rivets, forget about drilling them out in any accurate, simple fashion. So, new parts ordered! Secondly, the trim tab ended up warped. I think I may have bent it accidentally while trying to remove the plastic sheet from inside. Ordering new parts!

More elevator work

Image
I've been prepping the elevator metal. Found a better way to get my parts to dry after priming, put some small nails into my custom built shelving unit, and voila! First, here are all the parts nicely laid out: Then here they are drying: And here I am putting the trim tab together:

Horizontal stabilizer wait and elevator/trim tab start

Image
Well its official, apparently the front HS spar has to be nice and tight, so TAF is sending me some new parts! In the mean time, I'm starting the elevator. And the first part is the trim tab, which requires shortened rivets. Here is how I did it: First, hammer out the mandrel. I did this with the bench vise set at juuust the right opening (sorry, some blurry pictures ahead): Then, place the rivet upside down in a piece of spare sheet metal with a hole in it, held with a clamp. This holds it in place upside down. Then used a cutting wheel to cut off about half of the rivet's length. Finally, deburr the work a little bit: Then, back in the vise to put the mandrel back in: Repeat 32 more times!